Do a search in the archives here for Voice Board. There is a Ten Tec mod to
the voice board to install a diode to prevent the battery from running down,
while boards that were originally in Omni V and VI radios may not have had
that. You can test by just removing the board for a while to see if your
battery stays up.
I gather you are aware also there was a later revision to the Paragon that
provided a charging voltage for NiCd batteries, which could cause a problem
with Alkalines. Are you saying you see 12v on the battery terminals when the
rig is on?
=Vic=
WA4THR
----------------------------------------------------------------------------
------------------
To: tentec@contesting.com
Subject: [TenTec] Paragon 585 troubleshooting
From: Joe Hetrick <jhetrick@bitjanitor.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 26 Apr 2017 18:15:02 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hey folks,
I recently acquired a 585 that has some troubles. When I received it was
suggested I replace the 9V internal battery to revive the memories and such.
Upon inspection I discovered that the 9V hardness was corroded away due to
the
leakage of the 9V nicd in the rig, and there was a great deal of corrosion
on
the board.
Knowing I'd have to tackle the damage to the board and a handfull of IC's
at
some point, I made a note and dropped in the new nicd cell.
Rig worked fine for a couple of weeks, then, the cell ran down. I
replaced
it with an alkaline, which I had on hand, knowing the danger and made a note
to
get a new nicd. That too ran down in a couple weeks time. I assumed that
with
the first rechargable I put in, the charging circuit must be damaged from
the
previous battery leakage.
At this point, I had another charged nicd to replace the alkaline with and
I
put it in to discover that memory status wasn't restored between power
cycles..
So, I left the nicd in, rig running for a day, and then left the rig
connected
to live power for another day. No change. Checking the nicad shows a
charged
battery with 9V nominal.
If I check the voltage at the 9V connector, I see supply voltage, so,
something else is amiss.
I think I have two issues: damage to the main board due to cell leakage,
likely leading to the second issue. Looking around, I'm assuming I'm not
the
first person to have one of these with damage of this nature--what have
peoples
experiences been cleaning these up and rehabbing them?
The run-downs are also interesting, and i see that there was a mod (a
description of the symptom, but not the mod itself) where the voice board
would
cause the battery to drain; how can one tell if that mod has been performed,
and, what exactly is it?
Anything else anybody might add I should look for? Rig has the Geihl chip
in
it, and, everything else seems to work OK, outside of the obvious damage and
issues with the thing keeping its wits between uses.
73
Joe KC0VKN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|