Kevin and the gang
It’s been at leas eight years ago, but I’ve taken the front panel off of a
scout to replace a faulty meter.
Yes, the knobs have to come off, there are mounting nuts under them
and you will need to unsolder the wires to the mic connector. Be sure you take
photos or at least make a drawing of what wire goes where.
It’s a daunting task… good luck
mike, wb8vge
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never sure.
> On Apr 6, 2017, at 10:27 AM, Kevin Anderson via TenTec
> <tentec@contesting.com> wrote:
>
> Has anyone taken off the front panel of a Scout? In particular, anything I
> should know about dealing with the concentric knobs?
>
> I need to get access to the SPEED/RIT switch, as it functions in the RIT
> direction, but not to activate the SPEED settings. Either the switch itself
> is off center and the edge of the front panel opening is interfering, or bad
> connection, or bad switch itself.
>
> I took the top and bottom covers off, and took off the inner knob of one of
> the concentric knobs, but I am not sure what to do next. Being that parts are
> plastic, I don't want to just start grabbing things with pliers or other
> tools unless I have some clue what I am doing. My goal is to gain access to
> the back side of the front panel so I can check out the switches. Or is it
> easier to remove the speaker plate and go in from above?
>
> Thank you in advance for advice. I am not very experienced in this
> compartment.
>
> Cheers/73,
> Kevin, K9IUA
>
> ---------------------------------------
> Kevin Anderson, Dubuque IA USA, K9IUA
> k9iua (at) yahoo (dot) com
> ---------------------------------------
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|