[TenTec] OMNI VI Repair ?

["H. M. Motley, Jr," <hmmjr@comcast.net>]

I thought I had posted this before but I don't see it on the reflector so here 
goes again.


After more trouble shooting there is NO problem with the Omni VI.  It was the 
power supply that failed. It put out rated voltage under no or low load (hence 
the rig received) but fails under Tx load.  Another power supply put on line 
did the trick.  All now works!  That just goes to show I need to check all 
possibilities before jumping to a conclusion.


Thanks to all who sent me info on where to get an O6 repaired.  I will keep 
this handy for future reference!


73,

Puck W4PM


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec