Is this zero offset present when the radio is turned off as well?
If so, have you tried licking your finger and wiping across the front of the
meter?
This meter accumulates electrostatic charge that can take a long time to
dissipate and the spit ills it right away.
The Orion meter does have an adjustment for zero but you have to remove the
meter from the front panel and poke a pained adjustment tool through an access
hole i the front of the meter to center the zero.
Tis must e done with the meter vertical because it is not a very good meter i
terms of balance. If you adjust it while it is laying on its back, it will be
off by 3 S units when you stand it up.
Gary
> On Feb 8, 2017, at 4:30 PM, garyh <k4mt1950@charter.net> wrote:
>
> I have one more question. My Orion II S meter with no signal and antenna
> shorted reads S3. I have done the S meter alignment. Is there an S meter
> zero adjustment?
>
>
> Thanks
>
>
>
> Gary K4MT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|