Joe
It may be the relays on the low pass filter board for the upper
bands...pretty easy fix if that is the issue
73
Bryan K2BLC
On 2/6/2017 4:56 PM, Joe W2KJ wrote:
Howdy Ten Tec’ers:
A friend of mine has been trying, unsuccessfully so far, to get on the email
reflector so I told him I would see if I could get a response to his problem.
His Jupiter puts out 100W from 160M thru 20M….but the output gets progressively
lower from 50W out on 17M to just a few watts on 10M.
Is there something in common to those bands that could account for the low
output seen?
Is there a tune-upprocedure for the higher bands on the Jupiter?
Could one of the finals be bad causing the drop on the higher bands?
Any info/suggestions are most welcomed.
Thanks in advance.
73, Joe W2KJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
Bryan Lee Cornwell
blcornwell@k2blc.com
http://k2blc.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|