I think the crimp tool is very expensive but you really don't need it.
Solder the center conductor and lightly crimp the shield near the top
(above the level of insertion into the TMP jack) using diagonal cutting
pliers etc. You can solder the shield after crimping like this as well.
Barry N1EU
On Mon, Feb 6, 2017 at 2:17 PM, Fred <n8yx@neo.rr.com> wrote:
>
> Anyone know which crimp tool is used with the TMP series connectors and
> where to get them?
>
> On 2/6/2017 12:00 PM, tentec-request@contesting.com wrote:
>
>> 3. Re: Interstage coax cable w/ THP male connectors wanted
>> (Barry N1EU)
>>
>>
>> ----------------------------------------------------------------------
>>
>> ------------------------------
>>
>> Message: 3
>> Date: Mon, 6 Feb 2017 09:54:06 -0500
>> From: Barry N1EU <barry.n1eu@gmail.com>
>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>> Subject: Re: [TenTec] Interstage coax cable w/ THP male connectors
>> wanted
>> Message-ID:
>> <CAFmfzDvNvP+DXL7eaCc_o4kJyba=5cAqMNxzKLkLT0t3hibeHw@mail.gm
>> ail.com>
>> Content-Type: text/plain; charset=UTF-8
>>
>> fwiw, TMP connectors are available for do-it-yourself at
>> https://www.therfc.com/taiko.htm
>>
>> Barry N1EU
>>
>> On Mon, Feb 6, 2017 at 8:32 AM, David Perrin <dbperrin@gmail.com> wrote:
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|