TenTec
[Top] [All Lists]

Re: [TenTec] Repairs - Omni VII

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Repairs - Omni VII
From: Dukes HiFi <dukeshifi@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 23 Jan 2017 19:18:31 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I meant 588.RUF!


> On Jan 23, 2017, at 7:15 PM, Dukes HiFi <dukeshifi@comcast.net> wrote:
> 
> I just completed repair of an Omni VII for a fellow TT user. This radio would 
> lock into TX whenever keyed and required a power cycle to unlock it. Reset 
> process did nothing to help.
> 
> I thought I’d share the repair results with the reflector so that others 
> might benefit from my work.
> 
> At the outset of my investigation, I convinced myself that the radios was not 
> suffering from some sort of RF feedback that might have caused the thing to 
> lock up. i had seen Orion’s do that so this was my first choice in diagnosis. 
> I did this test by reducing the F power for the TUNE mode to 5 watts. Then I 
> also disconnected the drive to the RF amp to ensure that no significant RF 
> was being produced. The same failure mode occurred, all bands, all modes.
> 
> I then studied the operation of the TX/RX control design. This thinking 
> process was led by the possibility that something on the TX DC line might be 
> shorted. This is not possible, however, since every TX command in this radio 
> comes out of a MAX-232 serial port driver. Everything in the radio that would 
> make use of the TX data has its own serial command reading device.
> 
> The only thing really left on the table was firmware corruption. Therefore, I 
> went through a rather frustrating process of combining a good 599.RUF 
> firmware file with a working Ten Tec setup program since none of the ones at 
> TenTec.com <http://tentec.com/> work any longer and RKR is gone totally.
> 
> What I did was use a legacy version of Pegasus setup software and accessed a 
> known good copy of the 588.RUF firmware.
> 
> Viola! All seems working well. Firmware version is now 1.026.
> 
> I hope this saves someone out there some grief.
> 
> 73
> 
> Gary
> 
> W0DVN
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>