Only because it's easy to check-- AND overlook (Not that I have done such
things......).... is the correct antenna output selected?
73- Greg, KC8HXO
From: Rick via TenTec <tentec@contesting.com>
To: TenTec@contesting.com
Cc: wo8l@aol.com
Sent: Tuesday, January 10, 2017 5:48 PM
Subject: [TenTec] OMNII Problem
Hi,
I have an OMNI VII issue.
When I boot up the rig, it initially shows a 1.1 to 1 swr but quickly goes to
9.1.1 to 1 and won't transmit or tune up with the auto tuner or a big manual
tuner.
I've used two AC power supplies and a battery. Two antennas and a dummy load.
Same result. Sometimes the rig shows a high current message.
Have done partial and full resets to no avail.
Ideas?
It always worked fine before this.
Maybe the high current protecting rectifier is bad?
73s,
Rick
WO8L
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|