Jim, you probably have seen this already, but here's calibration info:
http://tentecwiki.org/doku.php?id=563calibrate
73, Barry N1EU
On Sat, Jan 7, 2017 at 6:50 PM, Jim Allen <jim.allen@longhornband.net>
wrote:
> I'll do my best. Parts Express shipping is 7-13 days. Being an OT, I was
> too cheap to pay for expedited shipping.
>
> I have been fiddling with the Omni VI+ recently, and it is still a very
> good radio, performance, especially ergonomics. This one is still reading
> 1.1 kHz. low and I can't figure out why, or how to bring it up to spec.
>
> Any suggestions gratefully received.
>
> 73 Jim Allen W6OGC
> Sent from my iPad
>
> > On Jan 7, 2017, at 12:23, Barry N1EU <barry.n1eu@gmail.com> wrote:
> >
> > Jim, could you possibly snap a photo after you mount the new speaker
> with a
> > note on how the install went? Many of us could benefit from the info and
> > I'll upload it to the TenTec wiki.
> >
> > Thanks & 73,
> > Barry N1EU
> >
> > On Sat, Jan 7, 2017 at 5:36 PM, Jim Allen <jim.allen@longhornband.net>
> > wrote:
> >
> >> Perfect. One is on the way!
> >>
> >> Many thanks. HNY
> >>
> >> 73 Jim Allen W6OGC
> >>
> >> Sent from my iPad
> >>
> >>> On Jan 7, 2017, at 11:13, Paul Kraemer <elespe@lisco.com> wrote:
> >>>
> >>> VISATON FRS8
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >>
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|