Re: [TenTec] HELP with broken off screw threads

[Bryan Lee Cornwell <blcornwell@k2blc.com>]

On 12/24/2016 10:06 AM, Peter Frenning [OZ1PIF] wrote:
> Den 24-12-2016 kl. 16:02 skrev Barry N1EU:
> > The threaded end of an aluminum screw broke off in one of the PCB 
> > mounting
> > posts in my Omni 6+.  Please have a look here: 
> > http://n1eu.com/screw1.jpg
> > I'd very much appreciate advice on how to remove that screw end.
> >
> > Thanks & 73,
> > Barry N1EU
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> Sorry Barry, I only get a partial picture...
I think a small "E-Z out" will work....something similar to this:

http://www.sears.com/irwin-hanson-5-pc-spiral-screw-extractor-set/p-SPM7648639823?plpSellerId=Antonline.com&prdNo=38&blockNo=38&blockType=G38

73

Lee K2BLC


--
Bryan Lee Cornwell

blcornwell@k2blc.com

http://k2blc.com

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec