That was done very recently and apparently disturbed in shipping. I am not
sure I have the facilities to do it myself.
73 Jim Allen W6OGC
Sent from my iPad
> On Dec 21, 2016, at 03:32, Harald Rester <harryrester@gmx.de> wrote:
>
> Jim, did you check the BFO alignment as well? Procedure for calibration
> starts there and you have to readjust the different trimmers several times.
> As I remember, TCXO calibration is the last step.
>
> 73, Harry, DH1NBE
>
>
>> Am 21.12.2016 um 00:56 schrieb Jim Allen:
>> I am in the process of checking calibration on this Omni VI+.
>>
>> When I zero beat WWV 10 MHz. the dial shows 9998.89.
>>
>> I put the radio in CW, and use a iPhone app, PANOTUNER which is used to
>> tune musical instruments and believed to be accurate within a hertz or so,
>> to set the zero tone to 700 Hz. which is what my sidetone is set for and
>> which is what the PANOTUNER shows it to be.
>>
>> The mystery is that the adjustment of what I think is the TCXO at the back
>> of the logic board, only moves the frequency a hundred hertz or so, not
>> enough to be able to zero with the readout at 10000.00.
>>
>> I have found the wiki on this, and some archival discussion from several
>> years back, and the process seems straight forward. It's just not working
>> as expected.
>>
>> Any ideas what I am missing, or what isn't right, here.
>>
>> TIA
>>
>> 73 Jim Allen W6OGC
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|