Tnx Barry,
I was reading eham reports (which I don't value very high) but there seemed
to be a lot of complaints about overloading on large antennas. Mine will be
on an all band dipole so it picks up plenty of signal from lots of bands.
I can use a preselector with it, I have a couple.
One thing I read that makes sense though I don't know if it is true, was one
should never place a direct conversion RX in a plastic enclosure.
73 - Rick, DJ0IP
(Nr. Frankfurt, Germany)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry N1EU
Sent: Friday, December 16, 2016 12:15 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] OT: SDRplay ???
I was just researching this Rick, contemplating adding a panadapter to my
Omni 6+. The SDRplay is a good performer in the $100-$150 range but if you
want to spend just a bit more ($200-$250), the Afedri (ethernet interface)
seems a better unit.
73, Barry N1EU
On Fri, Dec 16, 2016 at 4:00 AM, rick@dj0ip.de <Rick@dj0ip.de> wrote:
> How does the SDRplay compare to other SDR receivers in its price range?
>
> What else should I be looking at?
>
> Tnx
>
> 73
>
> Rick, DJ0IP
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|