PB T90 series relay or other? thanks..
> On Dec 11, 2016, at 10:57 AM, Mike Bryce <prosolar@sssnet.com> wrote:
>
> I might have one of those here in the pile. Let me know… yours for shipping
>
>
> Mike, WB8VGE
>
> Mike Bryce, WB8VGE
> the heathkit shop
> SunLight energy systems
> J e e p
> o|||||||o
>
>
>
>
>
>
>> On Dec 11, 2016, at 1:36 PM, denton sprague <denton@oregontrail.net> wrote:
>>
>> yeah, I garner that…
>> I surmise just about any common 12 vdc 30 amp relay will do the job also.
>> Will know more when I pull out the relay board this winter. Will upgrade the
>> dc power plug to an anderson power pole or something that is more current
>> capable at same time.
>>
>>> On Dec 11, 2016, at 10:23 AM, Mike Bryce <prosolar@sssnet.com> wrote:
>>>
>>> Yup! It’s a PB T90 series
>>>
>>> MIke, WB8VGE
>>>
>>> Mike Bryce
>>> prosolar@sssnet.com
>>>
>>> “The trouble with quotes on the Internet is that you never know if they
>>> are genuine”
>>>
>>> —Abraham Lincoln
>>>
>>>
>>>
>>>
>>>
>>>
>>>
>>>> On Dec 11, 2016, at 10:35 AM, denton sprague <denton@oregontrail.net>
>>>> wrote:
>>>>
>>>> Can anyone tell me if TT uses the potter & brumfield T90 series part no.
>>>> 475161 relays in both the Orion I and II rigs?
>>>> got this relay number off of a listing for an Orion I being parted out on
>>>> eBay.
>>>>
>>>>
>>>>> On Dec 10, 2016, at 8:43 AM, denton sprague <denton@oregontrail.net>
>>>>> wrote:
>>>>>
>>>>> If I slap the top of the Orion the relay will switch to off…when the
>>>>> power switch is in off position.
>>>>> Methinks mechanical…will know for sure when I pull out the relay board.
>>>>>
>>>>>> On Dec 10, 2016, at 8:25 AM, Steve Ellington <steven4lq@gmail.com> wrote:
>>>>>>
>>>>>> Measure the voltage across the relay coil and see if it's being hung up
>>>>>> by
>>>>>> voltage or just a mechanical problem.
>>>>>> Can you pull the cover off the relay?
>>>>>> Steve N4LQ
>>>>>>
>>>>>> On Sat, Dec 10, 2016 at 11:23 AM, denton sprague <denton@oregontrail.net>
>>>>>> wrote:
>>>>>>
>>>>>>> After several months of flakiness, the dc power relay in my Orion II
>>>>>>> decided to pretty much stay closed (on) all the time despite the front
>>>>>>> panel on/off switch position.
>>>>>>>
>>>>>>> Sometimes the relay will stay on for a few minutes, with the power
>>>>>>> switch
>>>>>>> in off position, then the relay will switch off.
>>>>>>>
>>>>>>> Shutting off the power supply itself until the Orion cools down just
>>>>>>> about always put the relay in the off position.
>>>>>>>
>>>>>>> So assuming the relay is just about toast, I am looking for the
>>>>>>> aftermarket part number and where to get the dc power relay…
>>>>>>>
>>>>>>> Anything else other than the relay that could be causing the problem?
>>>>>>>
>>>>>>> The power switch seems to be ok.
>>>>>>>
>>>>>>>
>>>>>>> _______________________________________________
>>>>>>> TenTec mailing list
>>>>>>> TenTec@contesting.com
>>>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>>>>
>>>>>> _______________________________________________
>>>>>> TenTec mailing list
>>>>>> TenTec@contesting.com
>>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>>
>>>>> _______________________________________________
>>>>> TenTec mailing list
>>>>> TenTec@contesting.com
>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|