I did find the Omni 5 process that Barry had referenced but this only covers
centering of the VCO.
I need to do the loop IF alignment.
There is a rectifying test point at the output of this stage and I assume that
there are adjustments to be made at differing frequencies using the DC voltage
developed at this test point in order to get proper gain across the entire
required bandpass of the VCO.
That’s the process I need.
Thanks,
Gary
> On Dec 10, 2016, at 12:07 PM, Dukes HiFi <dukeshifi@comcast.net> wrote:
>
> Now that I have repaired the PLL on the 5.5 mHz board of this Omni 6+ I am
> repairing, I need to align the loop IF amplifier and VCO centering.
>
> Is there a resource where I can find this process?
>
> Gary
>
> W0DVN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|