Barry. I just had a bout with one of my Corsair II's ALC LEDs. On the top
of the rig you'll find the Low Level Driver board toward the left rear.
There's a thumbwheel pot R15 that adjust the LED's firing point. The manual
gives the adjustment procedure on page 3-23
On Wed, Nov 23, 2016 at 3:59 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> I've got a Corsair II that is transmitting fine with full power output.
> But it seems like the ALC LED is functioning intermittently. Can anybody
> point me toward the source of the LED drive signal?
>
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|