TenTec Accessory Items For Sale:
Remote VFO, Speech Processor, Crystal Filters,
Power Supplies, Keyers, etc.
.
.
TenTec 263 remote VFO
The 263 is used with the TenTec Corsair (or Corsair II). In
addition to the normal split operation, it also permits one
to receive on two frequencies simultaneously, and vary the
relative signal of the two frequencies.
This one works fine and looks great. No scratches.
With paper work for $175.
.
.
TenTec 715 RF Speech Processor
The 715 is a newer iteration of the 234 processor.
It includes a bar graph, and other enhanced features.
A 15 volt DC wall wart is included to power it.
This one works fine and looks like new, with no
scratches.
With paper work for $190.
.
.
TenTec 288, 1800 Hz crystal filter
The 288 is used in the Corsair, as well as other TenTec rigs
such as the Paragon. It is 1800 Hz wide, making it great for
narrow SSB, but it is also terrific for wide CW, and is ideal
for digital modes.
Of course it works fine. With paper work for $75.
.
.
TenTec 217, 500 Hz CW filter
The 217 is used in the TenTec Omni (series B and C) and also
as roofing filters in the Orion I, plus most other earlier
TenTec rigs. It works great. With paper work for $85.
.
.
TenTec 218, 1800 Hz Filter
The 218 filter is great for narrow SSB, or wide CW. It is
used in the same rigs as the 217 filter above.
With paper work for $75.
.
.
TenTec 252 MO Power supply
The 252 MO provides 18 amps at 13 V DC to power most any
100 Watt HF transceiver. The physical styling matches
the TenTec Omni series, but it can be used on most 100 W
rigs. The 4 pin molex outplu plug matches man, many TenTec
rigs. This one works fine, and looks great.
With paper work for $75.
.
.
TenTec KR-20 A Single Paddle Electronic Keyer:
The KR-20 A is a single paddle keyer with the paddle actuation force
factory adjusted. It is basically the same as a KR-5 A keyer, with the
addition of a 110 V AC power supply.
Contact spacing adjustments are on the front. The weighting factor is
factory set for optimum smoothness and articulation. An Over-ride
"straight key" is conveniently located on the top for emphasis, QRS
sending or tune-up. It has reed relay output and a side-tone generator
with adjustable level.
117 VAC or 6-14 V DC. Finished in an etched aluminum panel and black
textured top and sides that matches the TenTec Triton IV and others of
similar vintage.
This particular unit works fine and looks extremely nice. It is in its
original box, with original paper work, including original warranty
card. $55
As above, but without original box. Works fine. $50
.
.
TenTec Combo Paddle and Electronic Keyers:
Both of these units have a single lever paddle included with the
electronics to make a combination paddle/keyer. Contact spacing
adjustments are on the front. The weighting factor is factory set for
optimum smoothness and articulation. Both include paper work.
KR-5 A An Over-ride "straight key" is conveniently located on the top
for emphasis, QRS sending or tune-up. It has reed relay output so can
key most any rig, and requires from 6 to
14 V DC. Finished in an etched aluminum panel and black textured top
and sides that matches the TenTec Triton IV and others of similar
vintage. This one works fine and looks fine. $40
Model 670 Similar to the KR-5 A above, but has a transistor output,
designed to key 13 V DC rigs. No over-ride button. Made to match the
Century 21. Looks and works fine. $30
.
.
I also have many other accessories from various manufacturers
available such as many different types of microphones, HTs,
VHF and UHF rigs, antennas, etc. Just too many things to
list here.
Please e-mail your requests.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|