That's not normal. I would do a full reset as follows.
1) Power off Orion.
2) Power On holding the VFO B LCK button.
3) Continue holding LCK button until the radio says "Battery Failure".
4) Power off Orion.
5) Power on holding "Main RX/TX" button.
6) Continue holding this button until the radio says reset complete.
7) Do not clear any settings when asked to do so.
8) Power the Orion off and back on one more time.
Write down all your settings first as this will reset everything.
Sometimes there is a stray value left in battery backed up RAM that
causes weird things to happen.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/1/2016 5:53 AM, Ron Stone via TenTec wrote:
Greetings to all.
I have an Orion 2 with Firmware 3.033xd. The SSB transmit sounds a whole lot better when
changed from 2400 to 2700KHz. However, when I turn the radio off, that setting is lost. I
have to re-input that setting every time I operate, which is tedious. Back-up battery was
changed about a year ago and in any case every other setting changed from default is
retained, except for the one I mention. Is this a common problem please or is it an oddie
on my radio? Does anyone know of a fix or work-around? I have tried storing it in
"USER" menu but it doesnt hold even with that.
73, Ron GW3YDX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|