If you don’t mind losing the auto select function, then I see no reason why
THAT would not work.
I rather liked that function but not everyone would, I guess.
Why do you want to put the 1.9 KHz filter into the 500 Hz slot?
Just curious...
Gary
> On Sep 16, 2016, at 11:39 AM, g3ory--- via TenTec <tentec@contesting.com>
> wrote:
>
> Gary
>
> Have I got this wrong then? On my Orion 1, in the Menu>Filter it
> appeared to me that I could select the xtal filter bandwidth OR Auto.
> I interpreted this as meaning that I could select a roofing filter
> irrespective of the DSP bandwidth setting.
>
> 73 Bob
> G3ORY
>
> ----Original Message----
> From: dukeshifi@comcast.net
> Date: 16/09/2016 14:25
> To: "Wolf Wita"<g4ssx@yahoo.co.uk>, "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Subj: Re: [TenTec] Orion
>
> The Orion automatically selects the roofing filter based on DSP
> bandwidth selection. Thus it assumes that a given filter is in a
> particular position on the board. If you put the incorrect filter into
> a slot, that function will not work properly.
>
> 73
>
> Gary
>
> W0DVN
>> On Sep 16, 2016, at 12:38 AM, Wolf Wita via TenTec <tentec@contesting.
> com> wrote:
>>
>> HiI have got a 1.9 khz Filter and i wonder if i could put it in the
> slot where the 500khz filter is? i already got a 1.9 filter in the 1.9
> khz filter in the slot.ThanksG4ssx wolf
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|