Rick, et. Al...
The HF115F-H-012-1Z relay has a substantial max. make time of 15 msec., whereas
the GH1/HC1/RJ1 are rated at 6 msec. maximum and are typically 1-2 msec. Even
if the typical make time of the HF115F is half the max. rating, it's still too
slow for several transceivers that cannot delay the RF envelope in a menu
setting. The HF115F is similar to a Tyco/Schrack model. They're generally
fine for switching RF, even at high power, but not high power at QSK switching
speeds. We need to pay attention to the relay's switching speed.
Paul, W9AC
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Rick@DJ0IP.de
Sent: Monday, August 22, 2016 5:05 AM
To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
Subject: Re: [TenTec] Replacement output T/R relays for TT linear amps.
If this is a BIG issue, I can buy a supply of these and store the with Scott
W4PA (Vibroplex/Spiderbeam/INRAD/etc.
I can ship them for free to him. Then you must only order in TN.
). I already receive their big catalog anyway.
Gunner, can you tell me exactly which relay it is... page number in catalog or
send a direct link please.
73 - Rick, DJ0IP
(Nr. Frankfurt, Germany)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of
gunnerjuulnyholm@me.com
Sent: Monday, August 22, 2016 10:40 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Replacement output T/R relays for TT linear amps.
Hi Jim.
After 15 years of CW usage the K1 antenna relay had to be changed in my
Centurion 422. I agree that the Gigavac relay is super, but if you are looking
for a direct and cheap replacement, you can get it from the German post order
company <www.reichelt.de <http://www.reichelt.de/>>. Their type no. of the
relay is HF115F-H-012-1Z, and the price is € 2,20. The contact rating is 440
Vac and 10 A. Same pin arrangement. - I’m sure that you also can afford a
postage of 7 €? Handling time < 24 hours.
You can’t avoid also receiving their inch thick catalogue with 1500 pages of
(almost) any electronic component at very affordable prices.
The change in the Centurion was quite simple. The relay is inside a sound
insulating box filled with rubber foam around the relay, but it is not
difficult to get the old relay out. I couldn’t put in the new relay in
precisely the same position, but I don’t hear the relay at all when using CW.
73 and good luck!
Gunner / oz6nf
> On 21 Aug 2016, at 23:11, w3ka@lycos.com wrote:
>
> Thanks Paul W9AC and Jim K9YC... This sounds like a great way to go.. tnx for
> the response..
> 73, Jim W3KA
>
>
>
> On 2016-08-21 20:27, Jim Brown wrote:
>
>> Agreed on all counts. Several years ago, an engineer in the Alpha booth
>> told me they use Gigavac. I've been using Gigavac as replacements for my
>> TenTec amps for about ten years. I bought them direct from Gigavac under
>> their ham discount program, and I still have a couple of new spares in my
>> parts stash. I don't remember the last time I had to replace a T/R relay --
>> I'd guess at least 5-6 years, and my operation is 90% CW. I do NOT usually
>> do QSK with those amps though, because of operating speed, the complexity of
>> keying loops with SO2R operation, and not wanting to have to replace a T/R
>> relay in the middle of a contest.
>> 73, Jim K9YC
>> On Sun,8/21/2016 1:01 PM, Paul Christensen wrote:
>>> Jim,
>>> If you're interested in a premium T/R relay, Gigavac makes the GH-1
>>> model and is identical to the Kilovac HC-1 and Jennings RJ-1, all of
>>> which have been time-tested over several decades.
>>> Gigavac sells direct to us:
>>> http://www.gigavac.com/catalog/amateur-radio
>>> Or, check with Alan Bond:
>>> http://www.mgs4u.com/RF-Microwave/vacuum-relays-SPDT.htm
>>> You'll need to specify coil voltage as all three vacuum relays are
>>> produced with several popular voltage ratings.
>>> Paul, W9AC
>>> -----Original Message-----
>>> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of
>>> w3ka@lycos.com
>>> Sent: Sunday, August 21, 2016 2:49 PM
>>> To: tentec@contesting.com
>>> Subject: [TenTec] Replacement output T/R relays for TT linear amps.
>>> Greetings to the group.. After years of QSK CW operation, the
>>> output T/R relays in my TT Centaur 411, and Centurion 422B are in need of
>>> replacement.
>>> When requesting parts info from Ten Tec, there have been no replies
>>> to my emails. Does anyone have a generic source (Mouser or Digi-key
>>> for example) and part numbers for the appropriate replacement relays?
>>> Tnx.. 73, Jim W3KA
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
🙏
Gunner
-----------------------------------------------
Gunner Juul-Nyholm OZ6NF-5P5S
Maglegårds Allé 93 B
DK-2860 Søborg
Danmark
Mobil: +45 4013 0044
www.godepenge.dk
www.positivemoney.org
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|