Bob,
When I pay so much money for a transceiver, I shouldn't have to start
manufacturing BPFs.
This is a simple case of the design engineer not fully understand the
application.
The fundamental problem is, people want to do two different things with
these radios.
Some with to use them as traditional radios, others want to use them for
broadband receivers.
These have two different sets of requirements.
In order to do both, you must have two different sets of (different kinds
of) filters.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Katz Ajamas
Sent: Sunday, July 17, 2016 6:59 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] OT: Question to the group.
No love for the Elad? I know the RX does not come with filters but the
transceiver?? Is it LPF only? No BPF? PA3AKE filter set looks nice.
https://martein.home.xs4all.nl/pa3ake/hmode/bpf_all.html It will cost almost
$100 and a lot of time.
Antennas are evolving at the ATL QTH. I mostly use a 80m Inverted Vee apex
about 70'. Fed with 450 Ohm OWL(open window line). A Big Johnson match box
in the shack for 80-10. Tuned feeder for 6. Working on antennas for 160 and
2.
I like the tuned feeder. With enough room in the shack one could make a set
with relay switching and use a 220' doublet on 160-6 without a tuner!
73, -Bob ah7i/w4
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|