TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI

To: John King <k5pgw@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI
From: Peter Klein <pklein@threshinc.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 12 Jul 2016 16:39:24 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
John:  This article and subsequent comments explains the differences:
<http://www.tentecwiki.org/doku.php?id=563upgrade>

Re. your main question:
/The later 564's replaced the crystal oven with a 2ppm TCXO on the logic board, probably the best enhancement TT did to this radio. The crystal oven eventually "cooks out" and will not hold frequency tolerances well. Try aligning one and getting it to hold frequency. The TXCO fixes that problem.//
/
Hope this helps!
--Peter, KD7MW

On 7/12/2016 4:13 PM, John King via TenTec wrote:
Does the early Omni VI  (1992-1993) and  The Omni VI opt.3 have the sane TCXO? 
What are the main differences between the two? Thanks, John, K5PGW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>