| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] OMNI D Help Needed |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 13 Jun 2016 13:47:37 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Joe, are there plug in cables you had to loosen to remove front panel?
If so unplug and replug a few times to loosen oxides; then invert the
sockets to shake out any debris.
Might be as simple as that for the dial readout issues. Stuart Rohre K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion, Byron Allen |
|---|---|
| Next by Date: | [TenTec] Argonaut V, J. Fielden |
| Previous by Thread: | Re: [TenTec] OMNI D Help Needed, Al Gulseth |
| Next by Thread: | Re: [TenTec] OMNI D Help Needed, k7mks |
| Indexes: | [Date] [Thread] [Top] [All Lists] |