Mike: I've removed those two screws and the trim ring is still hung up on
something and will not release from the panel. Have you removed a trim ring by
just removing those 2 screws and how did you do it?
Joe
----- Original Message -----
From: "Mike Bryce" <prosolar@sssnet.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, June 3, 2016 10:24:48 PM
Subject: Re: [TenTec] Omni Series Panel and Trim Ring
joe,
the trim ring comes off by two screws on the bottom, directly under the vfo
knob
mike
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/ <http://www.theheathkitshop.com/>
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never
sure.
> On Jun 3, 2016, at 11:11 PM, k7mks@comcast.net wrote:
>
> Starting to restore an Omni D Series B and have a need for a cosmetically
> nice front panel or a method to redo some letters or numerals that closely
> match the original.
>
> A previous owner went wild with an engraving tool on the trim ring and my
> options are to find a parts rig for a trim ring
> or to find some way to sand and fill the groves he cut and then repaint the
> trim ring. BTW - how do you get the trim piece removed.
>
> Many thanks joe k7mks
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|