I don’t think it is in the manual…
You will need do do a Master Reset again when you replace the battery. The
radio comes up in strange states sometimes if you do not do the reset.
> On May 5, 2016, at 9:50 PM, Barry LaZar <k3ndm@comcast.net> wrote:
>
> Gary,
> Many thanks. Do you know where in the manual, or elsewhere, you can find
> this? I've looked everywhere, I think.
>
> 73,
> Barry
> K3NDM
>
> ------ Original Message ------
> From: "Gary J FollettDukes HiFi" <dukeshifi@comcast.net>
> To: "Barry LaZar" <k3ndm@comcast.net>; "Discussion of Ten-Tec Equipment"
> <tentec@contesting.com>
> Sent: 5/5/2016 10:31:36 PM
> Subject: Re: [TenTec] Master Reset on Power up
>
>> Yes you need the battery.
>>
>> It is located on the front panel PC board.
>>
>> You remove the 12 flat head screws that hold the plastic front panel in
>> place and hinge the front open.
>>
>> You will see a yellow thing. That is the battery, a simple plug in device.
>>
>> It is a M4T28-BR12SH1 and DigiKey has plenty of them
>>
>> Gary
>>> On May 5, 2016, at 2:59 PM, Barry LaZar <k3ndm@comcast.net> wrote:
>>>
>>> I'm running the latest firmware on my Orion II, 3.033xe. When I do a power
>>> up, it tells me that the master reset is complete. The same thing was
>>> happening on the version of firmware just before. I suspect that the memory
>>> keep alive battery needs to be replaced, but my manual has no reference to
>>> it or anything about memory. Any ideas/comments??
>>>
>>> Barry
>>> K3NDM
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|