| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Centaur metering question |
| From: | Joe Papworth via TenTec <tentec@contesting.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 1 Feb 2016 11:40:33 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
The "FWD" meter reads low as compared to my in-line watt meter, which I know is accurate. I'm OK with that but I'm concerned about the grid current reading, since it uses the same meter and switch. (I've seen a lot of scuttle-butt about the metering switches being a problem) Any input is welcome. Later, Joe, K8MP _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] "It is Alive", Joe Papworth via TenTec |
|---|---|
| Next by Date: | Re: [TenTec] A ntenna Tuner Drive cord, k7mks |
| Previous by Thread: | [TenTec] "It is Alive", Joe Papworth via TenTec |
| Next by Thread: | Re: [TenTec] Centaur metering question, km2km |
| Indexes: | [Date] [Thread] [Top] [All Lists] |