TenTec
[Top] [All Lists]

Re: [TenTec] Paragon vs Paragon II - PLL

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon vs Paragon II - PLL
From: Bwana Bob <wb2vuf@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 20 Jan 2016 21:43:56 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I believe that they redesigned the PLLs for the Paragon II. The main issue with the PLL boards in the original Paragon was poor tinning of the component leads and the PWB.

            73,

            Bob WB2VUF

On 1/19/2016 9:29 PM, Gary J FollettDukes HiFi wrote:
I can’t speak insider facts here but I have had many Paragon 2 radios and none 
of them had PLL issues.

Gary



On Jan 19, 2016, at 5:17 PM, steve jobes via TenTec <tentec@contesting.com> 
wrote:

I have not had any problems with my paragon 2, and can't recall hearing of any 
issues with them.

73,
Steve W1DXH







-----Original Message-----
From: k7mks <k7mks@comcast.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Tue, Jan 19, 2016 6:14 pm
Subject: [TenTec] Paragon vs Paragon II  - PLL

Did Ten Tec make any performance improvements (ie soldered board conections, 
etc) in the later #586 PLL over the earlier #585 PLL's ?

Thank you. joe k7mks
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>