TenTec
[Top] [All Lists]

Re: [TenTec] Omni VII RX AUX socket

To: tentec@contesting.com
Subject: Re: [TenTec] Omni VII RX AUX socket
From: Gary Huber <glhuber@msn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 5 Jan 2016 17:38:36 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
1. it is RX only, TX is on ANT1 or ANT2
2. greater than -30 dBm
3. each RX port is -3dB down

73 ES DX,
Gary - AB9M

On 1/5/2016 11:20 AM, demerson wrote:
The Omni VII has a socket for a receive-only antenna, the AUX ANT.

1. Is this socket switched on transmit, or when in use is it permanently connected to the OMNI VII receiver input? 2. How much stray RF power can be allowed to reach this socket during OMNI VII transmit? More than 10 dBm? 3. If the N4PY mod cables are installed, to allow use of a 2nd receiver, does that affect the answers?

Unfortunately the simplified block diagram in the Omni VII manual doesn't show enough detail to answer these questions.

     Thanks,
              73
                     Darrel, aa7fv
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>