I use your fb software a lot also…but was looking for a setting from the front
panel or internally on the Orion….
Merry Christmas everyone!
> On Dec 21, 2015, at 12:36 PM, Carl Moreschi <n4py3@earthlink.net> wrote:
>
> You can do that with my N4PY Orion software by setting a tune power.
>
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 12/21/2015 3:20 PM, denton sprague wrote:
>> I run an orion with a palstar hf auto that requires only about 1-2 watts of
>> rf drive to auto tune…
>> is there an internal pot or setting to tweek from default setting of about
>> 10 watts to 1-2 watts?
>>
>> I usually back down rf output to about 1-2 watts to get the tuner to fire
>> and i works fine, but would be nice to leave the power out level set to 100
>> watts and have only a couple of watts rf output while in tune mode.
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|