That sounds correct to me.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 12/20/2015 5:24 PM, Ron Castro wrote:
I am planning on adjusting the driver and final bias on my Orion II, which is
something I have never done. I assume that the correct way to do it is by
inserting an ammeter in the B+ to each of the two drivers (Q1, Q2) and to the
pair of finals (Q3, Q4) and adjusting for the current shown on the schematic.
Would that be the correct way to proceed?
The last time it was at the factory, they found the bias out of adjustment and
one of the pots bad.
Thanks,
Ron Castro
N6IE
www.N6IE.com
Member:
ARRL
Redwood Empire DX Assn.
Northern California Contest Club
Northern California DX Foundation
Society of Broadcast Engineers
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|