| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Delta II intermittent RX (VCO issue?) |
| From: | "Mark Kenward" <k8vf_mark@centurytel.net> |
| Reply-to: | Mark Kenward <k8vf_mark@centurytel.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 12 Dec 2015 21:50:56 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Before you do anything else, check solder joints in vco 3 area on VCO board.....you will surely see some bad joints, or contaminated joints. Re solder anything in that are looking dull, or contaminated(wick off the ugly stuff first) Paragon II I got had this problem and was easily repaired once board was pulled... If it isn't too much trouble, just remove and re solder whole board. Just my 2 cents, from having same issue. K8VF _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Delta II intermittent RX (VCO issue?), Mike Bryce |
|---|---|
| Next by Date: | [TenTec] Ten Tec Order, terry foskey via TenTec |
| Previous by Thread: | [TenTec] Delta II intermittent RX (VCO issue?), Al Gulseth |
| Next by Thread: | Re: [TenTec] Delta II intermittent Issue, Ronf404 via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |