I found it on the TenTec Wiki at 565pwrdistfail - TenTecWiki. There are
variants, but Barry's was the the most recent.
| |
| | | | | |
| 565pwrdistfail - TenTecWikiDetailed analysis by K7HP of the 81936 A9 Power
Distribution Board - Orion 565 and Orion 566 OII (scroll down for latest
advice) (posts from the Ten-Tec and Orion Reflectors) April 6, 2007 |
| |
| View on tentecwiki.org | Preview by Yahoo |
| |
| |
Kim N5OP
From: Froiseth Richard <Rfwd6dok@centurylink.net>
To: Kimberly Elmore <cw_de_n5op@sbcglobal.net>; Discussion of Ten-Tec
Equipment <tentec@contesting.com>
Sent: Tuesday, December 8, 2015 1:16 PM
Subject: Re: [TenTec] How to Purchase Low-ESR Capacitors
Where can I get Barry’s Cap list?
73’sRich, WD6DOK
On Dec 8, 2015, at 10:41 AM, Kimberly Elmore <cw_de_n5op@sbcglobal.net> wrote:
I just replaced all the electrolytics on my O II A9 board with the recommended
capacitors researched by Barry, N1 EU. As I looked in the Mouser catalog, I
began to wonder: how can I determine which capacitors are the "low ESR" type?
It doesn't always seem obvious to me. Is there something I'm missing? Do I
simply use the ESR filter and select the lowest available ESR for the value I
want?
Kim N5OP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|