What? Work for a living? You and I are certainly in the minority.
Paul, W9AC
Sent from my iPhone6
> On Dec 8, 2015, at 8:58 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> I can but it will have to wait till after work today.
>
> 73, Barry N1EU
>
>> On Tue, Dec 8, 2015 at 8:44 AM, Paul Christensen <w9ac@arrl.net> wrote:
>>
>> Barry,
>>
>> Can you measure the Flex 6500 at say...a 2.8K filter setting? I know this
>> not a normal CW bandwidth for contesting but it would be helpful to see
>> what
>> timing changes have evolved since my last measurement.
>>
>> Paul
>>
>> -----Original Message-----
>> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry
>> N1EU
>> Sent: Tuesday, December 8, 2015 8:42 AM
>> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>> Subject: Re: [TenTec] TenTec Digest, Vol 156, Issue 4
>>
>> I just measured 170msec latency on the 6500 in cw receive. It's a lot (too
>> much for serious contesting IMHO) but it's not 350msec.
>>
>> My methodology was to transmit a single dit using another rig and used a
>> microphone/soundcard to record the tx sidetone of rig 1 and then the
>> received dit on rig 2.
>>
>> For comparison, my Orion II measured 45msec and my ANAN-100D SDR 70msec for
>> cw rx latency.
>>
>> 73, Barry N1EU
>>
>>> On Mon, Dec 7, 2015 at 8:23 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
>>>
>>> I will personally measure the latency of the Flex 6500 and get back to
>>> you. I'm not believing 350msec at this point.
>>>
>>> 73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|