Ron: I think you are right. I look at my books and they show a cable hooked
between the Omni VI and the amp.with the other end open. Another drawing shows
another cable hooked to the Molex end and to the amp and tuner.It's called 254
Extension Cable. The other DB 25 end is still open. Think it's used for the
remote tuning or computer.
You might go to the TenTec site and they still have the old manuals for
download. I can send you a copy but do notthink it would fly using the TenTec
reflector.
73 Clayton N4EV
From: Ron | K5XK <qrzthedx@gmail.com>
To: The other c tentec@contesting.com
Sent: Tuesday, October 20, 2015 3:13 PM
Subject: [TenTec] Help Identifying Omni 6 Cable
My documentation is misplaced and I need help identifying a factory
interconnection cable held-over from my Omni VI days. It has a DB-25 from
the interface port on the Omni 6 with a 2nd DB-25 in parallel (on a short 4"
cable), to a 15 pin molex (8 active pins). I'm pretty sure it was an
interconnecting cable between the Omni VI and the 253 auto-tuner and Herc II
amp, but isn't there was an additional cable that mated with the 2nd DB-25,
perhaps to the amp or 253 tuner?
Thanks/73, Ron, K5XK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|