[TenTec] Omni VI Meter Issue Question

["Brian Sarkisian, KG8CO via TenTec" <tentec@contesting.com>]

 I recently purchased a Ten Tec Omni VI and everything works great except meter.
The lowest the needle will go is S3 and that is with the RF gain all the way 
down and the antenna disconnected.
If I cycle the meter knob back and forth, the meter will drop a little bit, 
however, once the receiver hears a signal it will returnto the S3 position.
Looking for some suggestions.

Thank you

Brian, KG8CO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec