TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6 Plus: No RX or TX on 10 meters (Intermittent)

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6 Plus: No RX or TX on 10 meters (Intermittent)
From: "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 6 Jul 2015 15:21:02 +0200
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Did you guys have solder back then, Jim?
;-)

73 - Rick, DJ0IP
(Nr. Frankfurt am Main)


-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Jim Allen
Sent: Monday, July 06, 2015 2:47 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Omni 6 Plus: No RX or TX on 10 meters (Intermittent)

I'm glad you found the fix.

Why is it there are so many re-solder fixes these days.  I don't recall ever
hearing about resoldering on the old gear.  Anybody ever have to fix a 75A4
or SX101, etc. by resoldering some connections?

73 de W6OGC Jim Allen 

Sent from my iPad

> On Jul 6, 2015, at 7:39 AM, Joe Papworth via TenTec
<tentec@contesting.com> wrote:
> 
> It appears to be fixed and in repairing it, I fixed another annoying
problem, which was spurs and floaters on ten meters only. Those had been
plaguing me for several years.
> 
> 
> First, thanks to Paul at Ten Tec for pointing me in the right direction
and to Mark, K8VF, and others for their suggestions.
> 
> 
> Paul was right. The problem was on the Xtal Osc/LO board. The repair
process went like this:
> 
> 
> 1) I looked at the schematic of the board and saw there are 4 separate 
> xtal ? ? oscillators for ten meters (I assume one for each 500 Khz 
> band segment) ? ? Since I was losing the entire band, I knew it wasn't one
of those circuits.?
> ? ? That eliminated a lot of circuitry as a possible cause.
> 
> 
> 2) After reading the theory of operation, I pretty much narrowed things
down ? ? to the L9, L10, and L11 circuits, plus the Q4 and Q5 circuits.
> 
> 
> 3) I resoldered every component in those areas and voila, no more 
> spurs or ? ? floaters and so far, RX and TX are fine. (I'm fairly 
> certain the rig would ? ? have failed?by?now)
> 
> 
> Later, Joe
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>