Good suggestion Jim but 10 and 12 meters share the same pair of relays, so
it's not a relay.
In a message dated 6/25/2015 4:09:18 P.M. Eastern Daylight Time,
jim.allen@longhornband.net writes:
When I sent my Omni VI+ in for that, on 160,and low output on 30M, they
replaced the relays, all of them for each band.
73 de W6OGC Jim Allen
Sent from my iPad
> On Jun 25, 2015, at 2:42 PM, Joe Papworth via TenTec
<tentec@contesting.com> wrote:
>
> Radio Gurus,
> My Omni 6 Plus has an intermittant no RX/TX problem on ten meters only.
The
> freq display reads correctly and the ALC led comes on as it should when
I
> key the rig.
> I spoke with Paul at Ten Tec. He thinks it's almost certainly a problem
on
> the oscillator/LO mixer board. (I.e a Lock Pulse problem)
> I thought I'd run it by you guys before I rip into it.
> Later, Joe
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|