Let me try this again.
The my Orion 1, TX EN/TX OUT, both 1 & 2 will not key the Centurion - some
component in that circuit smoked this morning.
So, why not use the ARB to key the Centurion? Or am I overlooking another
source on the Orion to key the Centurion?
Miike
----- Original Message -----
From: "Rick - DJ0IP / NJ0IP" <Rick@DJ0IP.de>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, March 29, 2015 15:32
Subject: Re: [TenTec] Centurion
Why are you wanting to use that?
What transceiver are you using it with?
The Centurion does not need any MFJ stuff to be keyed properly from a
Ten-Tec transceiver.
It's useless baggage!
The ARB 704 is intended for using a newer transceiver with an old amp that
has a T/R relay with high voltage.
It is totally useless and excess to your needs if you have a newer amp and
newer transceiver.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of mcelmer1
Sent: Sunday, March 29, 2015 10:24 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Centurion
I want to interface a ARB 704 with the Centurion but can not figure out
where to connect the ARB.
Do I use the Key In or Key Out RCA's on the Centurion?
Mike
W8TRN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|