The filter skirt issue is about causing chirps, not clicks.
Barry N1EU
On Sat, Mar 7, 2015 at 9:21 PM, Ken Brown <ken.d.brown@hawaiiantel.net>
wrote:
> I recall some discussion about one cause of clicks in the Omni VI was the
> TX carrier BFO frequency being on the skirt of the default 9 MHz IF filter.
> The one that is used always for SSB TX to reject the unwanted sideband,
> and is also in the signal path for CW TX. That would be where the suggested
> solution of getting a different filter comes from. Before spending the
> money on a different filter, it should be possible to adjust the TX BFO
> frequency (perhaps the right word is mis-adjust) to put it further into the
> filter passband, and out of the skirt area. That should demonstrate whether
> the clicks go away. Your TX frequency would be inaccurate. I am not saying
> this is a long term solution, but rather a troubleshooting step.
>
> DE N6KB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|