TenTec
[Top] [All Lists]

Re: [TenTec] Paragon 585

To: "wa3fiy@radioadv.com" <wa3fiy@radioadv.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon 585
From: Jim Allen <jim.allen@longhornband.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 6 Mar 2015 09:05:28 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
That (relay failure) was given was the cause of the low 30M output and no 160M 
output on my Omni Vi+ this summer when I sent it in for repairs.  All 12 (I 
think) were replaced at that time.

73 de W6OGC Jim Allen

Sent from my iPad

> On Mar 6, 2015, at 8:52 AM, Lee WA3FIY <wa3fiy@radioadv.com> wrote:
> 
> Chuck mentioned on his web page that the Paragon only has 12 watts or so 
> output so he 
> suspects drive or PA problems if I read that correctly.  Could well be one of 
> those but there is 
> another possibility...bad relay on output low pass filter board.  If one or 
> more relays weld 
> closed this symptom will be present on several but not necessarily all bands. 
>  I've had that 
> happen twice over the last dozen years or so.  Once on a Pegasus and once on 
> a Paragon.  
> So checking out the LP filter relays might be a good place to start.
> 
> For what it's worth, the failures were two different types.  The Pegasus 
> simply had a wear out 
> failure.  The Pagagon failure was caused by a leaking 9 volt memory backup 
> battery.  The 
> leakage contaminated a lowpass filter board on the bandswitching lines 
> causing one or more 
> relays to be closed when they were not supposed to be.  Why would a relay 
> weld you ask?  
> I'm thinking that being closed when it was not supposed to be caused high 
> circulating 
> currents on the LP filter board welding one of the relay contacts.   Not sure 
> about that but I 
> am sure the relay had stuck contacts and the radio acted like it had PA 
> failure. A replacement 
> relay fixed the problem.   :-)
> 
> Good hunting!
> 
> -Lee-
> 
> WA3FIY
> 
> 
> 
>> On 4 Mar 2015 at 16:26, chuck adams wrote:
>> 
>> Thanks to all who have helped and are helping on the
>> Paragon 585 transceiver.
>> 
>> I have a manual on the way with the schematics.
>> 
>> I went to Home Depot and got a quart of Behr
>> Premium Plus Ultra Interior Semi-Gloss Enamel.
>> I took the cover in and they scanned it with their
>> magic wand to get the color.
> etc.
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> http://www.avast.com
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>