There's a much easier way with no relays at all. You would end up with
a spdt switch to select the receive only antenna.
Inside the Eagle, you will find cable #2. This cable carries the
receive signal to the Eagle receiver. All you have to do is cut this
cable and bring the two connections out of the back of the Eagle. One
end of the cable would go to the common of the spdt switch. The other
end of the cable would to the normally closed contact of the switch.
The receive antenna would go to the normally open contact of the switch.
That's all you need. No relays at all.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 1/15/2015 4:17 PM, Katz Ajamas wrote:
Any suggestions?
I'm thinking 3 SPST reed relays . One to switch the Tx antenna. One to
switch detuner for the Tx antenna. One to switch the Rx antenna. The reed
relays switch in ~1ms so the 17ms transmit antecedent is plenty. They are
rated for 10**7 cycles.
73, Bob ah7i/w4
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|