(I changed the subject again)
On Tue, Dec 30, 2014 at 7:16 AM, Rick - DJ0IP / NJ0IP <Rick@dj0ip.de> wrote:
>
>
> The single connector mod is for running the 9 MHz out the back of the
> radio.
> Take a look at your if filter board. Directly beside the Xtal filters you
> will find an unused TMP jack.
> This is the 9 MHz tap inside the newer Eagles. If all you want is to run
> the 9 MHz out the back, connect your TMP cable to this jack and solder the
> other end to one of the RCA Phono Jacks.
>
>
This is the output I used (RX366, but essentially the same receiver)
connected to LP-PAN with internal LP-PAN preamp installed. I found the
passband was not flat (12dB humps present) and signal levels were
compressed. I imagine it's possible that an external Clifton Labs buffer
amp might fix the problems but I didn't try.
Has anybody else used this output successfully with LP-PAN?
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|