The Corsair uses two signal lines to know whether to be in Receive or
Transmit.
They are called "R" and "T".
They are about +8v when active and 0v when inactive.
Only one can be active at a time.
The signal/voltages are available on nearly every board.
You need to locate them, preferably on the control board and check to see if
they are working correctly.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of gary
mankoff
Sent: Wednesday, December 24, 2014 4:09 PM
To: tentec@contesting.com
Subject: [TenTec] CORSAIR NO RX OR TX
CORSAIR LIGHTS UP ...
NO TX OR RX ...
WHERE SHOULD I LOOK ...
73...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|