The cover is marked with one end saying "toward front of radio".
Perhaps they initially provided the filter cover from an Eagle and they
eventually made a different cover for the RX-366.
No worries, it's working fine now.
Barry N1EU
On Wed, Dec 10, 2014 at 12:53 AM, Carl Moreschi <n4py3@earthlink.net> wrote:
> Any chance the cover can go on two ways and one is backwards?
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 12/9/2014 6:58 PM, Barry N1EU wrote:
>
>> Through trial and error I've discovered it's actually the other way
>> around. "Sub-Rx Slot 1" in the menu controls the slot toward the front of
>> the Orion, marked F1 on the board and F3 on the cover. I also realize I
>> might have a very early production filter cover that was subsequently
>> corrected and that would explain my confusion.
>>
>> 73, Barry N1EU
>>
>> On Tue, Dec 9, 2014 at 11:44 PM, Barry N1EU<barry.n1eu@gmail.com> wrote:
>>
>> Can an RX-366 owner out there confirm that filter slot F1 is toward the
>>> rear of the Orion and slot F3 is toward the front of the Orion? That's
>>> how
>>> it's labeled on the filter retaining cover but the silkscreen on the
>>> board
>>> itself where the filters plug in has it the other way around.
>>>
>>> Thanks& 73,
>>> Barry N1EU
>>>
>>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|