TenTec
[Top] [All Lists]

Re: [TenTec] OMNI-D Series C

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI-D Series C
From: Richards <jrichards@k8jhr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 22 Aug 2014 02:50:15 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
YES!

And... (he said in good humor) in another 20 years, you can upgrade to one of the current crop, and be even more amazed... but until then, ENJOY your new rig !! :-) I am sure it will prove a huge bargain and lots of fun to operate.

Good stuff IS good stuff ... further proof older radios do not go bad if other rigs are introduced.

Enjoy and good DX !

------------------------ K8JHR  ------------------------------

On 8/21/2014 7:47 AM, Alexander N. Gerli wrote:
Hi folks!  Well, something new and different in the shack. I've been
licensed since my 'teens (1964). It may have taken a few years (!), but I
just got my first Ten Tec xcvr! My OMNI-D is loaded and has the 255 P/S.
Even though it dates from the 1980s, it is a really nice radio. The first
thing I noticed was the RX noise floor - very quiet. The counter timebase
was off about 100Hz for WWV, and that was an easy adjustment.  Beats me why
I waited so long to get one of these. It is one fine rig.

Anxious to get on one of the Sunday Nets.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>