TenTec
[Top] [All Lists]

Re: [TenTec] OMNI D question

To: wb5jnc@centurytel.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI D question
From: Louis Ciotti <lciotti1@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 17 Aug 2014 22:27:11 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Not to thread jump, but any recommendatioins on a decent low cost hand mic
for use with the older TenTec rigs?


On Sun, Aug 17, 2014 at 9:44 PM, Al Gulseth <wb5jnc@centurytel.net> wrote:

> From the Ten-Tec Wiki: "Microphone Impedance: High impedance crystal,
> ceramic,
> or dynamic." (This applies to all the older TT rigs with a 1/4" phone jack
> for the mic connector.)
>
> 73, Al
>
> On Sun August 17 2014 8:22:21 pm Alexander N. Gerli wrote:
> > Is the OMNI-D mic input Hi- or Lo-Z?
> >
> > ​73,​
> >
> >
> > ​Sandy AC1Y​
> >
> >
> > Alexander N. Gerli, Sr.
> > 548 Allred Mill Road
> > Mount Airy, NC 27030-2202
> >
> > Scotsmen walk about 900 miles each year.
> > A Scotsman drinks around 45 gallons of Whisky a year.
> > Scotsmen get about 20 Miles Per Gallon.
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>