Vic, that will indeed take care of the interfacing, but if QSK CW is to be
used and you are driving it with an Eagle, the amp's T/R relay is going to
attempt to follow the keying, which it can't. Therefore you need to add a
post-dit delay (hang) to the keying. It should be a couple hundred ms.
Otherwise the racket will scare the dickens out of you.
Sometimes I forget the throw the switch on my model 913 to turn on the delay
and the moment I key CW, the amp starts dancing on the table! ;-)
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Vic Klein
Sent: Monday, July 28, 2014 2:23 PM
To: tentec@contesting.com
Subject: Re: [TenTec] A real post and question
I have an old linear (60's vintage) and to switch it I cobbled up a simple
circuit that has worked on 3 different radios without a problem. I got a
small 12v relay from radio shack and took 12v from the radio accessory jack,
through the relay, and to the NO amp switching connector on the back to the
radio. Be sure to put a diode across the relay coil to block reverse EMF
when the radio circuit opens. Then use the relay contact to switch whatever
you need....in my case a 110vac Dow Key relay that switches the antenna and
keys the amp.
=Vic=
WA4THR
----------------------------------------------------------------------------
--------------------
To: tentec@contesting.com
Subject: [TenTec] A real post and question
From: John Farler <k4avx1@windstream.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 25 Jul 2014 11:10:20 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
OK kids - (I used to be a school principal) Let's quit the arguing about
how many angels will fit on a pin, and make this the civil discourse it
should be, especially with all the good tech's here. John Henry has taken
on the SW project, and I dont care too much about lab comparisons, which, in
my view, have Gone to an absurb level that will not probably be noiced on
the air.
My problem is that I will ACTUALLY BE OPERATING during the KY WEEK COMING UP
TUE AS A W1AW/4 CENTENNIAL STATION. I have my regular station and SW setup
(Omn 6+ and Hercules II.) I took the TT deal and got an Eagle, which just
came in and I haven't had a chance to even hook it up. If I learn enough,
I'd like to get it on the air some.
I know it will switch SOME linears through the accessory jack, but would
like more isolation and more current head room on the switching lead,
without losing the necessary delay. I'm thinking the circuit might not be
very complicated.
Question is: Has anyone made such a gadget, or should I just get the TT
Accessory?
Thanks,
73,
John, K4AVX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|