It looks interesting. But I'm not spending US$1960 on a pig in a poke.
73, ron w3wn
On 06/04/14, Rick - DJ0IP / NJ0IP wrote:
Using a mic connector for its ext. 13.8v supply. Interesting.
And apparently they have a little brother to this one, without a built-in
PC.
See:
http://www.sunsdr.com/en/products/9-transceiver/33-the-ducddc-hvvhfsunsdr2-t
ransceiver.html
(that link will probably be broken by the reflector, so you will have to
repair it before using).
At least the one Barry point out has a few knobs!
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Barry N1EU
Sent: Wednesday, June 04, 2014 3:23 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] OT: new SDR
here's the rear panel: http://sunsdr.com/images/fbfiles/images/02_.jpg
On Wed, Jun 4, 2014 at 1:20 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> I know we've recently discussed SDRs on the reflector so please excuse
> this off-topic post. There's a nice looking SDR in the works out of
> Russia with its own front panel. It actually has an embedded i5
> processor. It is going to be introduced at Friedrichshafen. There
> have been quite a few youtube videos of it in prototype phase over the
> past year or so. Here's a
> photo: http://sunsdr.com/images/fbfiles/images/SunSDR2_MB1_1_.jpg
>
> I don't know anything else about it.
>
> 73, Barry N1EU
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
