TenTec
[Top] [All Lists]

Re: [TenTec] Eagle problem?

To: tentec@contesting.com
Subject: Re: [TenTec] Eagle problem?
From: Carter <k8vt@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 17 May 2014 17:57:33 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 5/15/2014 10:06 PM, Bob McGraw - K4TAX wrote:
My 256 ft center fed wire shows  a 1.0 amp current in one leg and a
> 1.1 amp current in the other leg.  One leg goes through the top of a
> tree while the other is over grass.  Depending on season, leaves or
> no leaves there is a noticed difference in balance/unbalance but no
> so as to cause a problem. These measurements were done with a single
> Weston RF Ammeter, 0 - 2A F.S., with internal thermocouple. Measure
> one leg and note the current and then measure the other leg. Pretty
> easy  What were the currents you measured?  .

Using a Palomar Engineers clamp-on RF ammeter, I measured 0.9 A in one leg and 1.3 A in the other on 20 meters.

73,
Carter   K8VT

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>