The command set for the Pegasus and RX320 is unique. No other radios
use this command set.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 5/16/2014 2:16 PM, Darrel wrote:
I have recently been using my RX320 and Pegasus to monitor the NCDXF
beacons, using the program Faros. (See http://www.dxatlas.com/faros/.)
This a great program for monitoring the beacons, and can tune the
receiver to different bands automatically. The list of rigs specifically
supported (see http://www.dxatlas.com/OmniRig/) includes the
Ten-Tec Paragon II, Ten-Tec Orion, Ten-Tec Omni VI+, Ten-Tec Omni VII
and TenTec RX-350, as well as many Kenwood, Yaesu, Icom and other rigs.
However, I have not succeeded in making the program control my TenTec
RX320 or Pegasus.
Does anyone know if the RX320 or Pegasus computer control protocol is
compatible with any of the other TenTec rigs listed above?
Thanks,
73
Darrel, aa7fv.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|