Kim, can not understand why you would spend the money on a dead horse. The Oll
is obsolete, I know I own one.Andy, W3LI
>
>
> Kim, FYI I posted to this list about my lack of success using the RX366
> 9MHz output to drive LP-PAN (w preamp). I believe the VE7TK mod that adds
> a Clifton Labs buffer amp to generate the 9MHz output will probably yield
> much more satisfactory results.
>
> 73/GL,
> Barry N1EU
>
>
> On Tue, May 13, 2014 at 1:36 AM, Kim Elmore <cw_de_n5op@sbcglobal.net>wrote:
>
> > I've just finished the installation of my new (and, apparently last) RX366
> > into my Orion II. Being the kind of ham that wants to have all the bells
> > and whistles available, even if I don't have the ability to use them right
> > now, I decided to go ahead and take advantage low-level the 9 MHz output
> > from the RX366. I obtained a length of coax with TMP connectors on both
> > ends and looked up the 9 MHz output mod by VE7TK. To my astonishment, I see
> > that one of the unused TMP receptacles on the back of the unit (the one
> > next to where cable 3 plugs in) goes to the RCA jack on the back labelled
> > "SPARE." I double checked and, sure enough, there's a DC path to the
> > "SPACE" RCA jack on the back. KEWL!
> >
> > So, apparently, all I need now is an LP PAN adapter unit with a preamp and
> > I'll be cookin' with a real-time spectrum display.
> >
> > Kim N5OP
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|